14
EN
Connecting Hose to Water Tap
Screw - Type Hose to Tap with Thread
Screw the hose connector to the water supply,
which has ¾” threaded union.
NOTE
•
Before connecting the inlet hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket,
and check the water temperature.
Connecting Hose to the Appliance
Screw the water line to the water supply on the
back of the appliance.
NOTE
•
After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. If
the tap is square or too big, remove the guide
plate before inserting the tap into the adaptor.
•
Make sure that the hose should not be kinked or
trapped.
Installing the Drain Hose
For Model with Drain Pump
The drain hose should not be placed higher than
100 cm
above the floor. Water in the appliance may
not drain or may drain slowly.
•
Securing the drain hose correctly will protect the
floor from damage due to water leakage.
_DN
•
If the drain hose is too long, do not force it back
into the appliance. This will cause abnormal
noise.
•
When installing the drain hose to a sink, secure
it tightly with string.
