40
EN
Symptoms
Possible Cause & Solution
Cycle time is longer
than usual.
Heavy articles are mixed with lighter items.
•
Always try to wash articles with similar weight in order to allow the
appliance to evenly distribute the weight of the load for spinning.
The load is out of balance.
•
Manually redistribute the load if articles have become tangled.
Duration is delayed
Unbalance is detected or suds removing programme is on.
•
This is normal. The time remaining shown on the display is only an
estimated duration. Actual time may vary.
Drying
Symptoms
Possible Cause & Solution
Dry problem
Check water supply tap.
•
Do not overload. Check that the washing machine is draining properly to
extract adequate water from the load. When load of laundry is too small to
tumble properly. Add a few towels.
•
Turn off water supply tap.
Drying performance is
too low or bad.
Water is not properly supplied. The water is used for auto-cleaning of
lint-filter on drum during the drying.
•
Make sure the water supply tap is open.
Water does not properly drain.
•
Make sure the drain filter is not clogged.
The appliance is overloaded.
•
Check the load capacity for the selected cycle. If necessary, add a time
dry cycle.
The spin speed is too low.
•
Select the highest spin speed allowed for the wash cycle.
Drying time is too
long.
The ambient temperature is low.
•
Make sure the temperature is allowable range.
A warm air comes out
from the rear side of
the appliance.
This appliance makes a warm air to dry the laundry.
•
This warm air dries the laundry and comes out from the rear side of the
appliance.
