14
EN
2
Adjust the level after placing the appliance in
the installation area.
3
Place the adhesive side
a
of the anti-slip
sheets on the floor.
•
The most effective way is to install the anti-
slip sheets under the front feet. If it is difficult
to place the sheets under the front feet of the
appliance, attach them under the rear feet.
4
Put the appliance on the anti-slip sheets.
•
Do not attach the adhesive side
a
of anti-slip
sheets to the feet of the appliance.
NOTE
•
Additional anti-slip sheets are available at LG
Electronics service centre.
Connecting the Water Inlet
Hose
Note for Connection
•
Water pressure must be between
100 kPa
and
1000 kPa
(1.0 - 10.0 kgf/cm²). If the
water pressure is more than
1000 kPa
, a
decompression device should be installed.
•
Do not overtighten the water inlet hose to all
valves.
•
Periodically check the condition of the hose and
replace the hose if necessary.
Checking the Rubber Seal on the
Water Inlet Hose
Two rubber seals
a
are supplied with the water
inlet hoses. They are used to prevent water leaks.
Make sure that the connection to taps should be
sufficiently tight.
Connecting Hose to Water Tap
Screw - Type Hose to Tap with Thread
Screw the hose connector to the water supply,
which has ¾” threaded union.