16
EN
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release the
connector latch plate. Make sure the adapter
locks into place.
Latch plate
NOTE
•
After connecting the supply hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.) in the
water lines. Let the water drain into a bucket,
and check the water temperature.
Connecting Hose to the Appliance
Screw the water line to the water supply on the
back of the appliance.
NOTE
•
After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. If
the tap is square or too big, remove the guide
plate before inserting the tap into the adaptor.
•
Make sure that the hose should not be kinked
or trapped.
Installing the Drain Hose
For Model with Drain Pump
The drain hose should not be placed higher than
100 cm
above the floor. Water in the appliance may
not drain or may drain slowly.
•
Securing the drain hose correctly will protect the
floor from damage due to water leakage.
_DN
•
If the drain hose is too long, do not force it back
into the appliance. This will cause abnormal
noise.
•
When installing the drain hose to a sink, secure
it tightly with string.
Summary of Contents for F4DV909H2
Page 48: ...Memo ...
Page 49: ... UX 1 YZUSKX 9 53 8 9 8 9 KR 1 2 1 9 8 9 RM IUS Q ...