33
EN
Download Cycle
Download a new and special cycle that is not
included in the basic cycles on the appliance.
Appliances that have been successfully registered
can download from a variety of specially cycles
specific to the appliance.
Only one cycle can be stored on the appliance at
a time.
Once cycle download is completed in the appliance,
the product keeps the downloaded cycle until a new
cycle is downloaded.
Standby Power Consumption
Standby power consumption
0.5 W
Network standby power consumption
2.0 W
The period of time after which the
power management function, or
a similar function, switches the
equipment automatically into standby
and/or off mode and/or the condition
providing networked standby
20 min.
Open Source Software Notice
Information
To obtain the source code under GPL, LGPL, MPL,
and other open source licenses, that is contained in
this product, please visit http://opensource.lge.com.
In addition to the source code, all referred license
terms, warranty disclaimers and copyright notices
are available for download.
LG Electronics will also provide open source code
to you on CD-ROM for a charge covering the cost
of performing such distribution (such as the cost of
media, shipping, and handling) upon email request
to
opensource@lge.com
.
This offer is valid for a period of three years after
our last shipment of this product. This offer is valid
to anyone in receipt of this information.
Using Smart Diagnosis
This feature is only available on the model with
c
or
d
logo.
Smart Diagnosis through the
Customer Information Centre
Use this function if you need an accurate diagnosis
by an LG Electronics customer information centre
when the appliance malfunctions or fails. Use this
function only to contact the service representative,
not during the normal operation.
1
Press the
Power
button to turn on the
appliance. Do not press any other buttons.
2
When instructed to do so by the call centre,
place the mouthpiece of your phone close to
the
Smart Diagnosis
icon.
Max.
10 mm
3
Press and hold the
Temp.
button for 3 seconds.
4
Keep the phone in place until the tone
transmission has finished. Time remaining for
data transfer is displayed.
•
For best results, do not move the phone
while the tones are being transmitted.
•
If the call centre agent is not able to get an
accurate recording of the data, you may be
asked to try again.
5
Once the countdown is over and the tones
have stopped, resume your conversation with
the call centre agent, who will then be able to
assist you using the information transmitted for
analysis.
NOTE
•
This function depends on the local call quality.
•
The communication performance will improve
and you can receive better service if you use the
home phone.
•
If the data transfer is poor due to poor call
quality, you may not receive the best diagnosis
service.
Summary of Contents for F4V9RCP Series
Page 46: ...Memo ...
Page 47: ...Memo ...
