56
TROUBLESHOOTING
Symptoms
Possible Cause / Solutions
Too much smoke
during the Self Clean
cycle.
Too much soil in the oven. Open the windows to get rid of the smoke from the
room. Turn the oven mode knob to select Self Clean. Wait until the light goes off
before trying to open the oven door. Wipe up the excess soil and reset the clean
cycle.
The oven door does
not open after a Self
Clean cycle.
The oven temperature is too high. Wait up to one hour for it to cool down.
The oven door is
not clean after a Self
Clean cycle.
•
Incorrect oven control settings. See Self Clean in the MAINTENANCE section.
•
The oven was heavily soiled. Clean up heavy spills before beginning the Self
Clean cycle. Heavily soiled ovens may need either a longer Self Clean or two
Self Clean cycles.
Clean and door flash
in the display
•
The self clean cycle has been selected, but the door is not closed.
- Close the oven door.
"Loc" message
appears when you
want to cook.
The oven door is locked because the temperature inside of the oven is too high.
Press and hold
Probe
for three seconds.
Oven control beeps
and displays an F
error code.
•
Check the main gas shut-off valve or
the oven gas shut-off valve and call
for service.
•
Remove the power from the range
for five minutes and then reconnect
the power. If the function error code
repeats, call for service.
CODE
CAUSE
F-3
Key short error
F-9
Oven not heating
The oven racks were
cleaned in a Self
Clean cycle.
Apply a small amount of vegetable oil to a paper towel and wipe the edges of the
oven racks. Do not use lubricant sprays.
Clock is flashing.
Power outage or surge. Reset the clock. If the oven was in use, you must reset
it by pressing the oven mode knob to the
Off
position. Reset the clock and any
cooking function.
“Burning” or “oily”
odor emitting from the
vent.
This is normal in a new oven and will disappear with use. To speed the process,
set a Self Clean cycle for a minimum of three hours. See Self Clean in the
MAINTENANCE section.
Strong odor.
An odor from the insulation around the inside of the oven is normal for the first few
times the oven is used.
Fan noise
•
A convection fan may automatically turn on and off.
- This is normal.
Fan operation
It is normal for the fan to operate periodically throughout a normal bake cycle in the
oven. This is to ensure even baking results.
Burners are not
lighting properly after
cleaning the cooktop
surface.
Make sure that the burner heads and caps are completely dry and properly
positioned.
When lighting just one
burner, clicking noise
is heard from all the
burners.
This is normal. Electric spark igniters from the burners cause the clicking noise. All
the spark igniters on the cooktop will activate when igniting just one burner.
