English
Product Specifications
Model Name
FS21GB
Width x Depth x Height (mm)
(Max.)
1159 x 761 x 1061
Weight (kg)
6.0
CAUTION
• This stand (model name: FS21GB) is designed exclusively for TVs
manufactured by LG Electronics Inc. For compatible TV series, please
refer to the below table.
• Using it with other equipment may render it unstable and cause injury.
Precautions before Installation
• The Gallery Stand does not include a power strip. In order to connect
a TV or other devices on the Gallery Stand, purchase and use a power
strip of an appropriate length (2.5 metres or more is recommended).
• The maximum weight mountable on the rear brackets of Gallery Stand
is 1.5 kg.
• Mounting a wireless router on the rear brackets of Gallery Stand causes
frequency interference due to the proximity of the wireless antenna
built into the TV and the wireless router, which may prevent the TV’S
artificial intelligence remote control from working properly.
• If you mount a set-top box on the rear brackets of Gallery Stand, the
remote control reception unit on the set-top box may be blocked,
causing problems with reception to the set-top box. (If problems with
the remote control reception continue, the issue may be fixed with the
enclosed IR repeater (signal extension cable).)
IR Repeater Mounting Guide
• For the positions of installation, please refer to
-
of Figure 9 in
the installation manual.
Reception unit
Lower end of Gallery Stand
Attach with facing forwards.
Transmission unit
Reception unit of the set-top box
Power connection
unit
USB terminal of the TV or the set-top box
Models Compatible with the Gallery Stand
Compatible Model Released in 2019
Product Group
Inches
Series
OLED
55/65
C9
B9
SUHD
55
SM98
SM96
SM95
SM90
55/65
SM89
SM86
SM85
SM83
SM82
SM81
SM80
Compatible Model Released in 2020
Product Group
Inches
Series
OLED
55/65
GX
CX
BX
NANO
55/65
NANO93
NANO91
NANO90
NANO87
NANO86
NANO85
NANO83
NANO81
NANO80
55
NANO95
Compatible Model Released in 2021
Product Group
Inches
Series
OLED
55/65
G1
C1
B1
A1
NANO
55/65
NANO75
NANO76
NANO77
NANO79
NANO80
NANO81
NANO83
NANO85
NANO86
NANO88
UHD
55/60/65
UP80
UP81
UP82
UP83
UP77
UP78
How to Prevent TV from Falling
Affix to Wall using
suitable screw
1 Fix the brackets on the rear part of the product and on the wall as
shown in the picture. Secure the product brackets and wall brackets at
the same height.
2 Verify that the product brackets and wall brackets are firmly fastened.
3 Use a cord to tie and connect the wall brackets. When moving a
product installed in this way, please untie the cord first.
• Install the TV in the horizontal position only.
• It is safe to install the product according to the installation method
to prevent the damage to the product or personal injury even if the
product is pulled forward.
• Install the TV near a wall to prevent falls when pushed.
Make the knot as in the drawing.
*MBM67484312*
(2104-REV01)
How to Adjust the Height on Both Sides of the TV on
Gallery Stand
• Loosen the screw halfway by using a Phillips screwdriver, adjust the
height on both sides of the TV as illustrated, and tighten the screw.
