21
INSTALLATION
ENGLISH
Connecting the Water Supply Hose
Note for Connection
• Water pressure must be between
50
kPa
and
800 kPa
(0.5
‒
8.0 kgf/cm²). If
the water pressure is more than
800
kPa
, a decompression device should
be installed.
• Periodically check the condition of the
water supply hose and replace the
water supply hose if necessary.
NOTE
• Do not overtighten the water supply
hose or use mechanical devices to
tighten onto the inlet valves.
• No further backflow protection
required for connection to the water
inlet.
Checking the Rubber Seal
Two rubber seals
A
are supplied with
the water supply hose. They are used to
prevent water leaks. Connection to taps
is sufficiently tight.
• Do not use mechanical devices such as
multi grips to tighten the water supply
hose. Ensure that the curved end of
the water supply hose is connected to
the appliance.
Connecting the Hose to the
Water Tap
Connecting Screw-Type Hose to Tap
with Thread
Screw the supply hose connector onto
the water supply tap. Hand tighten only
with the aid of a soft cloth. Do not
overtighten the supply hose with any
mechanical device.
NOTE
• After connecting the water inlet hose
to the water tap, turn on the water tap
to flush out foreign substances (dirt,
sand, sawdust, and etc.) in the water
lines. Let the water drain into a bucket,
and check the water temperature.
global_main.book.book Page 21 Tuesday, May 25, 2021 11:26 AM
Summary of Contents for FWV1117BTSA
Page 74: ...Memo global_main book book Page 73 Tuesday May 25 2021 11 26 AM ...
Page 75: ...Memo global_main book book Page 74 Tuesday May 25 2021 11 26 AM ...
Page 76: ...Memo global_main book book Page 75 Tuesday May 25 2021 11 26 AM ...
Page 77: ...global_main book book Page 73 Tuesday May 25 2021 11 26 AM ...