44
MAINTENANCE
EN
Cleaning the Appliance
Periodically &
Performing an
Emergency Water
Evacuation
Tub Clean
This is a special function to help clean the
inside of the appliance by soaking,
washing, rinsing and spinning.
Run this function
once a month
(or
more often if needed) to reduce build-up
of detergent and softener and other
residue.
• If there is a bad smell or mildew inside
the appliance, run this function
once a
week for 3 weeks
in addition to the
regularly prompted intervals.
NOTE
• The
tcL
message will be displayed to
alert to the recommendation of
operating this function.
1
Remove any clothing or items from
the appliance and close the door.
2
Open the dispenser drawer and add
anti limescale powder to the main
wash compartment.
• Tablets can be placed directly into
the drum as an alternative to
powder.
3
Close the dispenser drawer slowly.
4
Turn on the power, and then select
the
Tub Clean
.
5
Press the
Start/Pause
button to
start.
6
Leave the door open to dry the inside
of the appliance completely.
• When the inside of the appliance is
not dried completely, it may cause a
bad smell or mildew.
WARNING
• Leave the door open to dry inside of
the appliance only if the children are
supervised at home.
Cleaning the Water Inlet Filter
The water inlet filter collects lime or any
sediment that may be in water that is
supplied to the appliance. If the water is
very hard or contains traces of limescale,
the filter on the water inlet may clog
regularly.
• Turn off the water supply taps to the
appliance if the appliance is to be left
for a certain period of time (e.g.
holiday), especially if there is no floor
drain (gully) in the immediate vicinity.
•
1E
error message will be displayed on
the control panel when the water is not
entering the detergent drawer.
1
Turn off the power and the water tap
and then unscrew the water inlet
hose.
