LG GB33 Series, Owner'S Manual

14

ENGLISH

CARE & MAINTENANCE

General information

Power failure

1~2 hour power failure does no harm to the foods 
stores. Try to avoid opening and closing the door 
too frequently.

If you move

• Take out foods from the fridge-freezer and fi rmly fi x 
the loose items with tape.

• Turn the leveling screws until they stop before 
moving the fridge-freezer. Otherwise the screw may 
scratch the fl oor or the fridge-freezer cannot move.

Anti condensation pipe

The Anti-Condensation pipe is 

installed around the front side of 
fridge and freezer, only freezer as 
well as on the partition between 
fridge compartment and freezer 
compartment to prevent dewing.

Especially after installation or when ambient 
temperature is high, the fridge-freezer may feel hot, 
which is quite normal.

Defrosting

Defrosting takes place automatically.
The defrosting water fl ows down to the evaporating 
tray and is evaporated automatically.

To reverse the doors

Your fridge-freezer is designed with reversible doors, 
do that they may open from either the left of right 
hand side to suit your kitchen design.

CAUTION

However, when you want to reverse the doors, you 
must call to service agent. Reversing the doors is 
not covered by the warranty.

Cleaning

Before cleaning

Be sure to unplug the power.

Exterior

Clean the outside of the fridge-freezer with a soft 
cloth soaked with hot water or liquid detergent. If 
you use a detergent, be sure to wipe it with a clean 
wet cloth.

Interior

Same as above.

After cleaning

Check that the power cord is not damaged, power 
plug has not overheated, and that the power plug is 
tightly inserted into the outlet.

WARNING

Be sure to dry the appliance with a cloth after 
washing it with water.
Do not use abrasive, petroleum, benzene, thinner, 
hydrochloride acid, boiling water, rough brush, 
etc, as they may damage parts of the fridge-
freezer.

Drip tray

Wipe moisture out around the door part and the 
drip tray using a clean cloth.

Exterior dispenser

Wipe moisture out of dispenser and on the dis-
penser pad using a cloth.

Water tank

1. 

Turn the knob shutter to open. And pull out 
the water tank assembly.

2. 

After unlocking the clamp and remove it, clean 
and fully rinse the inside/outside part of the 
water tank by using neutral cleansing agent.

Cap assembly tank and cap tank

Clean and fully rinse the cap assembly tank & cap 
tank by using neutral cleansing agent.
Especially for the groove part of the cap tank, it is 
convenient to cleanse it by using a small brush.