A. DOOR
1. Loosen 3 screws holding an upper hinge to separate the
door body. (Figure 7)
B. THERMOSTAT
1. Pull Konb Dial.
2. Loosen 1 screw holding the case and pull it out to
remove the Thermo cover. (Figure 8)
3. Pull out thermostat in the theremostat cover, and
disconnect lead wires.(Figure 9)
NOTE
: Replace a new thermostat with proper specification.
C. COMPRESSOR AND PTC
1. Remove Protector Cover, Power Cord and Lead Wire
first. (Figure 10)
2. Separate OLP.
3. Separate PTC.
4. Remove the Compressor Base by loosening 4 bolts
fixed to base plate of the set. (Figure 11)
5. Remove the Compressor by loosening 2 earth screws
next to Compressor.
NOTE
: Replace the Compressor, after peeling off
painted part of earth terminal.
• Compressor inhales the gas evaporated from Evaporator
and condenses this gas and then delivers to Condenser.
• PTC is abbreviation of Positive Temperature Coefficient
and is attatched to the Compressor, and operates motor.
• OLP prevents Motor coil from being started inside
Compressor.
• Do not turn the Adjust Screw of OLP in any way for
normal operation of OLP.
3. DISASSEMBLY
- 5 -
Figure 7
Figure 10
Figure 11
Figure 8
Figure 9
Note: Reversing the doors is not covered by the
warranty.
