GHX-308A/616
HYBRID KEY TELEPHONE SYSTEM
Http://suryawardana.com
70
Range : Yes/No
Default : No
Procedure :
1. Press FLASH button.
2. On a display phone, you will see this display;
INCOMING CO TOLL YES/NO
NO
3. To make change, press the top left program button.
LED Off : No
LED On : Yes
4. Press HOLD button.
ATTENDANT STATION ASSIGNMENT (FLASH 15)
The attendant will receive unattended recalls, i.e., transfers and holds after the initial recall attempt has been made.
The attendant places the system into the night service by pressing the DND button.
Parameters:
The system identifies a station as the attendant for line recall and attendant features. There can be a maximum of
one(1) attendant station.
Default:
Station 100
Procedure:
1. Press FLASH button and dial 15.
2. On a display phone, you will see this display:
ATTN STA ASSIGNMENT
100
3. Enter the 3-digit station number on the numeric keypad.
4. Press HOLD button.
Conditions:
1. The attendant is by default assigned to station 100. When assigned to any other station,
the attendant cannot be the programming entry station.
2. Recalls to the attendant will continue to ring until answered or disconnected, or the
attendant recall timer expires.
LOUD BELL CONTROL (FLASH 16)
Intercom calls, CO line transfers and CO ringing will be presented to an externally connected loud ringing device via
contact closure.
Two sets of control are provided to allow external ringing. Both contacts may be assigned to stations and the contacts
will operate when station is ringing.
Parameters:
Two stations can be assigned to Loud Bell Control. The LBC contacts on MDF inside the KSU will allow the ringing
assignments of those stations.
