•
The Anti-Condensation pipe is
installed around the front side of
freezer as well as on the partition
between freezer compartment to
prevent dewing.
•
Especially after installation or
when ambient temperature is
high, the freezer may feel hot,
which is quite normal.
Care and Maintenance
General Information
How to disassemble each
component
Power Failure
•
1~2 hour power failure does no harm to the foods
stored. Try to avoid opening and closing the door
too frequently.
It can be possible to disassemble only when the door
is opened by 90° or wider. Disassembling should be
done by the reverse order of assembling.
If You Move
•
Take out foods from the freezer and firmly fix the
loose shelves, draws and accessories with tape.
•
Do not move the freezer by sliding.
Anti Condensation Pipe
Cleaning
Before Cleaning
Be sure to unplug the power or shutdown the
main switch in your house.
Exterior
Clean the outside of the freezer with a hot
damp cloth with or without cleaning detergent.
If you use a detergent, be sure to wipe it with a
clean wet cloth.
After Cleaning
Check that the power cord is not damaged,
power plug has not overheated, and that the
power plug is tightly inserted into the outlet.
Interior
As above.
Lift up the shelf cover, and then
slightly lift up and pull out the
front of the shelf to remove.
1
3
2
Upper shelf
Pull out the drawer, and then slightly lift up
and pull out the front to remove.
1
2
Lower drawer
w
w
WARNING
Be sure to dry the appliance with a cloth after
washing it with water.
Do not use abrasive, petroleum, benzene,
thinner, hydrochloride acid, boiling water,
rough brush, etc,
as they may damage parts of the freezer.
17
ENGLISH
