USING YOUR REFRIGERATOR
FILTER
It is recommended that you replace the filter
when the water filter indicator reaches
0
or the
water dispenser or icemaker noticeably
decreases production.
Remove the old cartridge.
1.
Rotate the knob of the old cartridge
counterclockwise. When the cartridge is
released, you will feel it click out of place.
NOTE:
Replacing the filter causes a small
amount of water (around 1 oz. or 25 cc) to drain.
Place a cup under the filter hole to contain it.
2.
Remove the old cartridge. Take the new
cartridge out of its packaging, and remove the
protective cover from the o-rings. Hold the
cartridge handle in its vertical position, and
firmly push the new filter cartridge into place
until it stops.
Replace with a new cartridge.
1.
Use the handle to twist the cartridge clockwise
about one turn, until the handle is in a
horizontal position. You will feel the filter click
into place.
NOTE:
If the filter will not turn from side to side, it
isn’t fully inserted.
After replacing the filter, dispense for 2 minutes
from the water dispenser to purge the water
system. Check the filter for leaks.
When the water filter indicator displays the
message
0 Filter Month, Hold 3 Seconds
, reset
the water filter status display and indicator light
by pressing and holding the LIGHT/FILTER
button for more than 3 seconds.
To purchase replacement water filter cartridges,
visit your local appliance dealer or parts
distributor.
33
LIGHT / FILTER
ENGLISH
Summary of Contents for GRL2187EP
Page 44: ......