NOTE :
Only one jumper should be installed on the jumper connector.
If more than one jumper is installed, the drive may malfunction or be damaged.
Master/Slave setting is determined by jumper installation on the Jumper Connector.
The following table shows the possible jumper settings.
If you use CSEL setting, the MASTER/SLAVE setting will be made automatically,
depending on the hardware configuration. For more details refer to the manual of
your computer.
PC Connection
The Super Multi DVD Rewriter connects to the motherboard of the host computer
using an IDE interface cable. You may connect the Super Multi DVD Rewriter as a
Slave or Master device, depending on your computer.
To Install as a Master Drive
To install the drive as a Master, the jumper can be left as supplied from the factory.
NOTE :
A hard disk is normally installed as the Primary Master on the EIDE (ATAPI)
interface. Other EIDE peripheral devices such as hard drives and Super Multi DVD
Rewriters are then set differently.
6
Name
Function
Drive set as Master
Drive set as Slave
MA (Master)
SL (Slave)
CS
(Cable Select)
C
S
S
L
M
A
Drive mode set by CSEL on the host IDE interface
Primary
connector
Secondary
connector
Master drive (Super
Multi DVD Rewriter)
(Jumper left as Master)
Motherboard
- OR -
DIGITAL
ANALOG
INTERFACE
POWER
D
R
C S M
S L A
G L
G
39
1
+5
+12
GND
40
2
AUDIO
AUDIO
Master drive
(Booting hard disk)
Secondary
connector
Master drive (Super
Multi DVD Rewriter)
(Jumper left as Master)
Slave drive
(Other IDE
drive)
DIGITAL
ANALOG
INTERFACE
POWER
D
R
C S M
S L A
G L
G
39
1
+5
+12
GND
40
2
AUDIO
AUDIO
DIGITAL
ANALOG
INTERFACE
POWER
D
R
C S M
S L A
G L
G
39
1
+5
+12
GND
40
2
AUDIO
AUDIO
Master drive
(Booting hard disk)
Primary
connector
