LG HT902SB, Owner'S Manual

21

Operation

Presetting the Radio Stations

You can preset 50 stations for FM and AM (MW).
Before tuning, make sure that you have turned down
the volume.

1. Press TUNER on the remote control until FM or

AM (MW) appears in the display window.

2. And then every time you press TUNER, FM and

AM (MW) changes alternately.

3. Press and hold TUN.(-/+) for about two seconds

until the frequency indication starts to change,
then release.

Scanning stops when the DVD/CD Receiver tunes in a 
station.

4. Press PROG./MEMO. on the remote control.

A preset number will flash in the display window.

5. Press PRESET (-/+) on the remote control to

select the preset number you want.

6. Press PROG./MEMO. on the remote control again.

The station is stored. 

7. Repeat steps 3 to 6 to store other stations.

To tune in a station with a weak signal 

Press TUN.(-/+) repeatedly in step 3 to tune in the
station manually.

To clear all the stored stations 

Press and hold PROG./MEMO. for about two seconds
and “ERASE ALL” is appeared in the display window
and then press PROG./MEMO. again, the stations are
cleared.

If you have accidentally entered into the "ERASE
ALL" mode and you do not wish to clear the
memory, do not press any key. After a few seconds,
"ERASE ALL" will go off by itself and change to
normal mode.

Note:

If all stations have already been entered, the FULL
message will appear in the display window for a
moment and then a preset number will flash. 
To change the preset number, follow the steps 5-6 as
above.

Listening to the Radio

Preset radio stations in the DVD/CD Receiver’s
memory first (see “Presetting radio stations” on the
left).

1. Press TUNER until FM or AM (MW) appears in the

display window.

The last received station is tuned in.

2. Press PRESET (-/+) repeatedly on the remote

control to select the preset station you want.

Each time you press the button, the DVD/CD Receiver
tunes in one preset station at a time.

3. Adjust the volume by rotating VOLUME on the

front panel or by pressing or - on the
remote control repeatedly.

To turn off the radio 

Press POWER to turn the DVD/CD Receiver off or
select another function mode (DVD/CD, AUX, USB).

To listen to non-preset radio stations 

Use manual or automatic tuning in the step 2.

For manual tuning, press TUN.(-/+) repeatedly.

For automatic tuning, press and hold TUN.(-/+) for
about two seconds on the front panel.

To select a preset radio station directly

You can use the number buttons on the remote
control to select a preset radio station directly.
For example, to listen to the preset station 4, press 4
on the remote control. To listen to the preset station
19, press 1 and then 9 (within 3 seconds). 

For your reference

If an FM program is noisy

Press MONO/ST. on the front panel to make
“STEREO” disappear in the display window. There
will be no stereo effect, but the reception will
improve. Press the button again to restore the
stereo effect.

To improve reception

Reorient the supplied antennas.