25
S
ys
tem Se
tting
3
Audio
5.1 Speaker Setup
Make the following settings for the built-in 5.1
channel surround decoder.
1. Select [5.1 Speaker Setup] on the [Audio] menu.
2. Press
b
ENTER
.
The [5.1 SPEAKER] appears.
3. Use
AD
to select the desired speaker.
4. Adjust options using
WSAD
buttons.
5. Returns to the previous menu by pressing
x
RETURN
.
[Speaker]
Select a speaker that you want to adjust.
Certain speaker settings are prohibited by the
Dolby Digital licensing agreement.
,
,
Note
[Size]
Since the speaker settings are fixed, you cannot
change the settings.
[Volume]
Press
AD
to adjust the output level of the
selected speaker.
Front L/R : 0 - -5
SubWoofer, Rear L/R, Center : 5 - -5
[Distance]
After you connected speakers to your unit,
set the Distance between the speakers and
your listening point if the distance of Center
or Rear speakers is bigger than the distance
of Front speakers. This allows the sound from
each speaker to reach the listener at the same
time. Press
AD
to adjust the Distance of the
selected speaker. This distance is equivalent to
a difference of the distance between Center or
Rear speaker and Front speakers.
[Test]
Select [Speaker Test Start] by using the
WS
and press
b
ENTER
. Press
b
ENTER
again to
stop. Adjust the volume to match the volume
of test signals memorized in the system.
System Setting
HT906TA-A2_DARELLK_ENG_9802.indd 25
2013-11-19 �� 1:42:59
