Manual recording
This is the function used to record a TV programme or signal from
external equipment onto a video cassette tape. The set cannot
record any programme in the NTSC system as the NTSC system is
only for playback.
1. Insert a tape with a safety tab into the cassette compartment.
2. Press the REC/ITR button for a few seconds until the display
REC
appears on the screen. The REC/ITR indicator will
illuminate.
3. When the desired recording is completed, press the STOP
button. If the tape reaches the end before you press the STOP
button, the set automatically stops, rewinds to the beginning
and ejects the tape.
Note :
a. If you try to insert a tape without a safety tab, it will be
automatically ejected to prevent accidental erasure. If you want
to use the tape without the safety tab, stick a small piece of tape
over the safety tab hole.
b. If you don't wish to monitor while recording, press the
MONITOR ON/OFF button.
WARNING
Unauthorised recording of copyrighted programmes, films, video
tape and other materials may infringe upon the right of copyright
owners and be contrary to copyright laws.
Instant timer recording (ITR)
This function is convenient when you want to start recording
immediately without going through the entire timer setting
procedure. You don't have to set the time to use this function.
1. Insert a tape with a safety tab.
2. Press the REC/ITR button for a few seconds until the display
REC
will appear.
3. Press the REC/ITR button again. The display
ITR 0:00
will
appear.
4. Repeatedly press the REC/ITR button to set the recording
length, which appears on the screen. You can select up to 9
hours at 30-minute intervals.
After recording for the preset time, the set switches to standby.
To cancel the ITR function, press the REC/ITR button until the
display
ITR 0:00
appears.
17
REC/ITR
MONITOR
ON/OFF
STOP
Summary of Contents for KI-14U30
Page 25: ......
