LG KI-14U30, Owner'S Manual

Installation                      

Contents

Power

This set operates on a mains supply of 230V AC, 50Hz. In the

event of thunderstorms or powercuts, please pull out the aerial and

mains plugs.

Wiring

This set is supplied with a BS 1363 approved 13 amp mains plug,

fused at 5 amp. When replacing the fuse always use a 5 amp BS

1362, BSI or ASTA approved type. Never use this plug with the

fuse cover omitted. To obtain a replacement fuse cover contact

your dealer or "LG Electronics U.K. Ltd.".
If the type of plug supplied is not suitable for the mains sockets in

your home, then the plug should be removed and a suitable type

fitted. Please refer to the wiring instructions below:

Warning

A mains plug removed from the mains lead of this set must be

destroyed. A mains plug with bared wires is hazardous if inserted

in a mains socket.
Do not connect either wire to the earth pin, marked with the letter E

or with the earth symbol       or coloured green or green and yellow.
If any other plug is fitted, use a 5 amp fuse, either in the plug, or at

the distribution board.

Important

The wires in this mains lead are coloured in accordance with the

following codes:

BLUE:     NEUTRAL

BROWN: LIVE

As the colours of the wires in the mains lead of this set may not

correspond with the coloured marking identifying the terminals in

your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal

which is marked with the letter N or coloured black. The wire which

is coloured brown must be connected to the terminal which is

marked with the letter L or coloured red.

Service

Never remove the back cover of the set as this can expose you to

very high voltage and other hazards. If the set does not operate

properly, unplug it and call your dealer.

Aerial

Connect the aerial cable to the socket marked 

+

75

§ Ù

on the back 

cover. For the best reception an outdoor aerial should be used. 

Location

Position your set so that no bright light or sunlight falls directly onto

the screen. Care should be taken not to expose the set to any

unnecessary vibration, moisture, dust or heat. Also ensure that the

set is placed in a position to allow a free flow of air. Do not cover

the ventilation openings on the back.

Moisture condensation

Under special conditions, like moving your set from a cold to a

warm room, moisture condensation can build up on the head drum,

one of the most crucial parts of each VCR.

In order to prevent in such case any damage to your VCR HEAD

DRUM, connect the set power cord to the AC line, switch on the

main power button on the back cover and allow at least 2 hours for

the set to dry out.
Condensation is likely to occur when:

1. The video recorder is moved from a cold room to a warm room

or from outdoors to inside your home.

2. A cold room is heated quickly.

3. The humidity is very high.

3