6
1
Pull out the battery holder with a sharp product
like a ball point pen.
2
Put the battery with
and
correctly on the
battery holder.
3
Push the battery holder back into its original
position.
Note
• Use only one CR2025 (3V) lithium battery.
• Remove the battery if the remote control is not
used for a long period of time.
• Do not leave the product in a hot or humid place.
• Do not handle the battery with metallic tools.
• Do not store the battery with metallic materials.
Before installing, make sure that the ignition-switch is set to
OFF and remove the terminal of the car battery to avoid
short-circuiting.
1
Remove the existing receiver unit.
2
Make the necessary connections.
3
Install the installation sleeve.
4
Install the unit into the installation sleeve.
A
A
Bend the claws
according to
the thickness
of the
dashboard
Control panel
If there is already an installation sleeve for the receiver unit
in the dashboard, it must be removed.
1
Remove the rear support from the unit.
2
Remove the control panel and trim ring from the unit.
3
Insert the lever
A
into the hole on one side of the unit.
Perform the same operation on the other side and pull
the unit out from the mounting sleeve.
5
4
3
1
2
6
Control panel
1
Slide the unit into the ISO-DIN frame.
2
Fit screws removed from the old unit.
3
Slide the unit and frame into the dash opening.
4
Install the dash panel or adapter plate.
5
Install the trim ring to the unit.
6
Install the control panel to the unit.
Battery Installation
Basic Installation
Removing the existing receiver unit
ISO-DIN Installation
Installation
