5 Troubleshooting
Troubleshooting
18
Trouble
shoo
ting
5
Troubleshooting
No woofer sound
You can set up wireless connection manually, when
your connection is not completed.
1. Adjust volume level of the main unit to
minimum.
-
”VOL MIN” appears on the display window.
YRO#PLQ
Z#UHVHW
ZO#UHVHW
VOL
2. Press and hold (MUTE) on the remote control
for about 3 seconds.
-
“W RESET” / “WL RESET” appears on the display
window briefly.
YRO#PLQ
Z#UHVHW
ZO#UHVHW
VOL
or
3. If the LED of the wireless subwoofer already
blinks in green continually, you can skip this
step. Press and hold
PAIRING
on the back of the
wireless subwoofer for more than 5 seconds.
-
The LED of the wireless subwoofer lights up
alternately in red and green.
Red
Green
4. Disconnect the power cord of the main unit
and the wireless subwoofer.
5. Connect them again after the LED of the main
unit and the wireless subwoofer is fully turned
off. The main unit and the wireless subwoofer
will be paired automatically when you turn on
the main unit.
-
When the connection is completed, you can
see the green LED on the subwoofer.
Green
In case that sounds are cut off
during playback
y
For best performance of wireless connection
such as Bluetooth or wireless subwoofer, do not
install the unit on Metallic furniture because
wireless connection communicates through a
module positioned on the bottom of the unit.
y
Be careful not to make scratches on the surface
of the Unit /Sub-Woofer when installing or
moving them.
y
It takes a few seconds (and may take longer)
for the main unit and the subwoofer to
communicate with each other and make sounds.
y
The closer the main unit and the subwoofer,
the better sound quality. It is recommended to
install the main unit and the subwoofer as close
as possible and avoid the cases below.
-
There is a obstacle between the main unit and
the subwoofer.
-
There is a device using same frequency with
this wireless connection such as a medical
equipment, a microwave or a wireless LAN
device.
