CAR CD/MP3/WMA Receiver
7
Installation
A
A
If there is already an installation
sleeve for the receiver unit in the
dashboard, it must be removed.
1
Remove the rear support from the
unit.
2
Remove the control panel and trim
ring from the unit.
3
Insert the lever
A
into the hole on
one side of the unit.
Perform the same operation on
the other side and pull the unit out
from the mounting sleeve.
5
4
3
1
2
6
Control panel
1
Slide the unit into the ISO-DIN
frame.
2
Fit screws removed from the old
unit.
3
Slide the unit and frame into the
dash opening.
4
Install the dash panel or adapter
plate.
5
Install the trim ring to the unit.
6
Install the control panel to the unit.
Removing the existing receiver unit
ISO-DIN Installation
Before installing, make sure that the
ignition-switch is set to OFF and
remove the terminal of the car battery
to avoid short-circuiting.
1
Remove the existing receiver unit.
2
Make the necessary connections.
3
Install the installation sleeve.
4
Install the unit into the installation
sleeve.
Bend the claws
according to
the thickness
of the
dashboard
Control panel
Basic Installation
Summary of Contents for LCS700BN
Page 22: ......