Before Operation
PREP
ARA
TION
17
Setting the Clock
11
Press CLOCK.
(If the clock requires setting, press and hold CLOCK
for more than 2 seconds.)
- The hours display begins to blink.
2
2
.
Select either the 12 hour cycle or the 24 hour
cycle by turning MULTI JOG DIAL.
3
3
Press SET to confirm the selected hour cycle.
4
4
Use MULTI JOG DIAL to set the current hour.
5
5
Press SET.
6
6
.
Use MULTI JOG DIAL to set current minutes.
77
Press SET and the correct time is shown on the
display.
8
8
Press CLOCK at any time to show the time on
the display, for about 5 seconds.
Sleep Timer Function
When the sleep timer is set, the unit automatically turns
off after the specified time has elapsed.
11
To specify the time delay before the power is
turned off, press SLEEP.
In the display window you can see
for
about 5 seconds. This means that the system turns
off automatically after 90 minutes.
Each time the button is pressed the time interval
before it turns off is reduced by 10 minutes. i.e.
80...70... etc. Select the desired time to turn off.
2
2
To check the remaining time until the power is
turned off.
While the sleep function is active press
SLEEP
briefly. The time remaining until the unit turns off is
displayed for about 5 seconds.
ote
If you press
SLEEP
while the sleep time is displayed,
the SLEEP time is reset.
To cancel Sleep Timer setting
If you wish to stop the function, press the
SLEEP
button
repeatedly until “
SLEEP 10
” appears, and then press
SLEEP
once again after “
SLEEP 10
” shows on the
display.
Using Microphone
You can sing to a music source by connecting a
microphone to the unit.
11
Connect your microphone to the MIC socket.
“MIC” will be shown in the display window.
2
2
Play a music you want.
3
3
Sing along with the accompaniment.
Adjust the microphone volume by turning MIC
VOLUME KNOB.
For your reference
You can record during using microphone.
Refer to the “Recording” explanation section.
otes
When not using the microphone, set the MIC volume
knob to minimum or turn off the MIC and remove the
microphone from the MIC socket.
If the microphone is set too near the speaker, a
howling sound may be produced. In this case, move
the microphone away from the speaker or decrease
the sound level by using the MIC volume control.
If sound through the microphone is extremely loud, it
may be distorted. In this case, turn the MIC volume
control toward minimum.
To Adjust ECHO Volume
You can give an echo effect to the sound from the
microphones.
Turn ECHO VOLUME KNOB (ECHO VOL.) clockwise to
increase the sound level, or counterclockwise to
decrease it.
(12HR)
(24HR)
or
Summary of Contents for LF-D5933
Page 40: ...P NO MFL38637191 ...
