BEFORE & AFTER INSTALLATION
Before Installation
5
Please carefully read this manual before installation.
Solar module installation and maintenance must be
performed by qualified and authorized installer.
All installation instructions should be read and
understood before performing any installation.
Do not touch the solar module with bare hands.
It may result in a burn or injury.
Do not disassemble the solar module.
After installation or repair, check that the solar module
are operating properly.
In the event that the currently used solar module or p
arts have been replaced the newly replaced module a
nd parts must have the same model name and parts a
s the previously installed solar module.
In the case of a different model name replacement,
After Installation
Plug in the connector tightly and ensure that the wiring
properly works.
electrical characteristic model within 80% of the maximum
Conduct periodic inspection of the panels for damage
to front glass, back sheet, frame, junction box, or
external electrical connections.
Check electrical connections for loose connections
and corrosion.
PV panels can operate effectively without ever being washed,
although removal of dirt from the front glass can increase
output.
Water, ethanol or a conventional glass cleanser with a
micro-fiber cloth can be used for regular washing or ri
nsing of the front glass to remove dust, dirt or other de
posits.
Do not use ground water containing calcium carbonate
components when cleaning glass.
Aggressive and abrasive cleansers or chemicals such
as alkali chemicals including ammonia based solution
should not be used on cleaning the module.
Always keep the back surface of the panel free from a
ny foreign objects or structural elements which could c
ome into contact with the panel, especially when the p
anel is under mechanical load.
Deposits of foreign material on the frame surface can
be cleaned by using a wet sponge or cloth and dried i
n air or by using a clean chamois.
Perform the wiring work by connecting the connector
and wires to the stand away from the roof or ground.
Do not use any kind of oil or lubricant on the module's
any parts, It can defect the PV Module.
voltage of the system.
Do not let anyone approach the solar module who has lit
tle knowledge of solar modules or on the measures to ta
ke when solar modules are damaged in order to avoid th
e risk of injury or electrical shock.
Secure all necessary permits and licenses to install
the solar modules.
Do not locate the solar module horizontally, as this may
cause dirt or white efflorescence(glass deformation).
Panels are not intended for use indoors or on moving
vehicles of any kind.
Industry standard rated specifications are made at
conditions of 1000W/m
2
irradiance and 25
°C (77°F)
solar cell temperature. Colder temperatures may su
bstantially increase voltage and power.
Keep the solar module and system away from children
at all times.
Keep the module packed in the carton until the time of
installation.
Keep flammable gasses away from the installation
site.
Do not work alone. Please work as part of a team of
two or more people.
Safety harness use is strongly recommended for
installation.
Be careful not to damage the cable when using a tool
such as a knife to remove the cable tie that fixes the j
unction box cable.
Partial shadowing may substantially reduce panel and
system output and may be the reason for the damage
of solar module.
Care must be taken to avoid low tilt angles which may
cause dirt to buildup on the glass against the frame ed
ge.
Dirt build-up on the surface of the panel may cause
active solar cells to be shaded and electrical perfor
mance to be impaired.
it is possible to replace an equivalent or higher
