— 17 —
6. Roof vented installation:See Figure 33
Install ductwork through the vent opening in the
upper cabinet. Complete the venting system
through the roof according to the method needed.
See “PREPARE THE VENTING SYSTEM,” STEP
2 on the page 8. Use caulking to seal exterior roof
opening around the exhaust cap. See Figure 6 on
page 8.
7. Use power supply cord clamp to bundle the power
supply cord. Install the power supply cord clamp,
using a screw as shown in Figure 34, to inside of
the cabinet.
8. To install the grease filter: Slide it into the slide
slot, then push up and toward oven center to lock.
See Figure 35.
9. Plug in the power supply cord.
10. Read your Owner’s Manual, then check the
operation of your microwave oven.
STEP 6:
ATTACH THE OVEN TO THE WALL
Figure 33
Figure 35
Figure 34
damper
duct
power
supply
cord
clamp
