LG LMVM2033BM, Installation Instructions Manual

STEP 3: 

Prepare The Venting Blower

WALL-VENT

ING

 INSTALLATION:

1. Remove one or two blower unit mounting screw(s) and one

or several blower plate mounting screw(s). Remove the

blower plate from 

the 

cabinet. See Figure 1

3

.

2. Carefully lift the blower unit out of the microwave oven.

3. Use side cutters or tin snips to cut and remove knockouts

B from Back plate. Discard knockouts. Be careful not to

distort the plate. See Figure 1

5

.

4. Reassemble the blower wire. See Figure 1

6

.

5. 

Rotate and reinstall the blower unit so that the exhaust
ports face the rear 

of the cabinet

 and are aligned with the 

    rear cut-outs. See Figures 1

7

 & 1

8

.

6

. Reattach the blower plate to microwave oven so the exhaust

ports and blower plate opening are aligned. Attach with one

blower unit mounting screw and then one or several blower

plate mounting screw(s). See Figure 1

9

.

7

.

Insert the tabs on each side of the damper into the holes

    at the inside rear of the adaptor. 

Attach the exhaust adaptor to the 

back plate wall side.

Push in securely until it is past the

 top locking tabs

and in the lower locking tabs. Take care to

 assure

the damper hinge is installed so that it is at the top
and that the damper swings freely. 

See Figure 

20

.

Figure 1

3

Blower Plate
Mounting Screw

Blower Plate

Back Plate

Blower Unit
Mounting Screw

Blower Unit

Parts B

Figure 1

4

Blower

Unit

Exhaust Ports

Figure 1

5

Figure 1

6

Figure 1

8

Blower Plate
Mounting Screw

Blower Plate 

Back Plate

Blower Unit
Exhaust Ports

Blower Unit

Blower Unit 
Mounting Screw

Figure 1

7

Exhaust
Ports

– 1

0

 –

Slide exhaust
adaptor into
guides on 
rear panel.

Exhaust Adaptor

Damper 
(hinge side up)

Locking 
Tabs

Guides

Figure 

1

9

 See Figure 

14

.

Parts B

Knockouts Parts B

Figure 

2

0

or