LG LMVM2033BM, Installation Instructions Manual

– 

2

 –

Your Safety First

BEFORE YOU START

• Proper installation is the installer's responsibility!

  Proper installation by a qualified technician or installer is recommended.

NOTE: Vent grille appearance varies by model.

BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:

• Avoid Electric Shock!

– Before you drill into the wall, note where electrical outlets are and where electrical wires might be concealed

behind the wall. 

YOU COULD GET AN ELECTRIC SHOCK

if you contact electrical wires with your drill bit.

– Locate and disconnect the power to any electrical circuits that could be affected by installing this oven. 

IF YOU DO NOT DISCONNECT THE POWER, YOU COULD GET AN ELECTRIC SHOCK.

• ELECTRICAL RATING OF THIS OVEN : 120V AC 60Hz.

– You need a DEDICATED 120V, 60Hz, AC only, 15 or 20A, fused electrical supply (located in the cabinet

above the microwave as close as possible to the microwave) serving only the microwave.

Model Number Plate

Figure 1

For 

Y

our Safety

W A R N I N G

Figure 2 

• THIS APPLIANCE MUST BE GROUNDED!

– If there is an electrical short circuit, grounding reduces the risk of electric 

shock by providing an escape wire for the electric current. This appliance

is equipped with a cord having a grounding wire with a grounding plug.

•

 Place the plug into a properly installed and grounded outlet. See Figure 3.

•

 Do not use an extension cord.

•

 Keep the power cord dry and do not pinch or crush it.

 Failure to follow this instruction may cause a fire hazard.

• DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE 

POWER SUPPLY CORD GROUNDING PRONG!

This appliance MUST be grounded!

PROPERLY POLARIZED AND

GROUNDED OUTLET

Three-Pronged (Grounding) Plug

Figure 3

If you use the grounding plug improperly, you risk electric shock and/or fire!

Check with a qualified electrician if you are not sure whether the oven is properly grounded or if you do not

completely understand the grounding instructions.

DO NOT USE A FUSE IN THE NEUTRAL OR GROUNDING CIRCUIT.

Improper grounding could result in electric shock, fire or other personal injury.

– Read the entire manual before you begin. The model number label is located on the oven front. 

See Figure 1. The mounting plate is located on 

the upper packing

. See Figure 2.

w

• This oven should not be installed or located by anyone except properly qualified service personnel.

• You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled

properly. 

W A R N I N G

w

w

W A R N I N G

Mounting Plate

Mounting Plate

or