8-1-4 ICE PLUS selection
Please select this function for quick freezing.
• Function is repeat ICE PLUS Icon whenever pressing ICE PLUS button.
• ICE PLUS function automatically turns off after a fixed time passes.
8-1-5 Dispenser use selection
1. Water
* Water switch: Hold your cup in the dispenser for a few
seconds with pressing water switch to allow the last drops
of water to fall into the cup.
* Active water button: Place big bowl on the dispenser bottom
with pressing active water button to allow the last drop of
water to fall into the bowl.
* When after initially establ ishing the water comes out, the water tank inside fills and until at the time of quality the hour is caught.
2. Ice
* You can select cube or crushed ice.
* Select cube ice or crushed ice by cycling through the selections when pressing the CUBE/ CRUSH button.
* Hold your cup in the dispenser for a few seconds with pressing ice switch to allow the last pieces of ice to fall into the cup.
8-1-6 DISPENSER LIGHT
-Whenever pressed the LIGHT button, DISPLAY is changed as belows.
Normal status: When dispenser is operated, DISPENSER LIGHT is ON.
ON status: DISPENSER LIGHT is on continuously.
8-1-7 CONTROL OF FREEZER FAN MOTOR
1. Freezer fan motor has high and standard speeds.
2. High speed is used at power-up, for Ice Plus, and when refrigerator is overloaded.
Standard speeds is used for general purposes.
3. To improve cooling speed, the RPM of the freezer fan motor change from normal speed to high.
4. High speed (2700RPM) : Initial power on or load corresponding operation, Ice Plus
Normal speed (2400RPM) : General working conditions.
5. Fan motor stops when refrigerator or freezer door opens.
8-1-8 Cooling Fan Motor
1. The cooling fan is switched ON and OFF in conjunction with the compressor.
2. The cooling fan runs at a single speed.
3. The Failure sensing mathod is the same as in the fan motor of the freezing fan motor(refer to failure diagnosis function
table for failure display).
8-1-9 Icing Fan
The Icing Fan is controlled by the the sensor on the top of the ice room.
The Failure sensing mathod is the same as in the fan motor of the freezer
(refer to failure diagnosis function table for failure display)
- 29 -
PUSH
ACTIVE WATER BUTTON
WATER SWITCH
ICE SWITCH
ICE TYPE
www.Appliantology.org
