36
Removing the Warming Drawer
Disconnect the electrical power to the range at the
main fuse or circuit breaker panel. Failure to do so
can result in severe personal injury, death, or electri-
cal shock.
WARNING
Most cleaning can be done with the drawer in place; how-
ever, the drawer may be removed if further cleaning is
needed. Use warm water to thoroughly clean.
1. Fully open the drawer.
2. Remove the two screws.
Remove screws
Lever
Push down with finger
Pull up with finger
Lever
3. Locate the glide lever on each side of the drawer. Push
down on the left glide lever and pull up on the right
glide lever.
Remove screws
Lever
Push down with finger
Pull up with finger
Lever
4. Pull the warming drawer away from the range.
Replacing the Warming Drawer
1. Pull the bearing glides to the front of the chassis
glide.
2. Align the glide on each side of the drawer with the
glide slots on the range.
3. Push the drawer into the range until levers “click ”
(approximately 2 inch).
4. Pull the drawer open again to seat bearing glides into
position.
5. Replace the two screws.
CARE AND CLEANING