- 8 -
SURFACE CONTROLS COOKING
LOCATIONS OF THE RADIANT
SURFACE ELEMENTS AND
CONTROLS
The radiant surface elements are located on the cooktop as
below.
The radiant control key locations are correlative to radiant
surface elements on the cooktop as shown below.
PF
(Power Failure) MESSAGE
The PF message will appear whenever there has been a
power interruption to the appliance. To clear the PF message
press ON/OFF control pad to reset and be sure to reset the
clock with the correct time of day.
HS
( Hot Surface) MESSAGE
LIGHT WILL:
&RPHRQZKHQWKHXQLWLVKRWWRWRXFKDIWHULWLVWXUQHGRII
&RPHRQGXULQJ6HOI&OHDQLQJ&\FOH
6WD\RQHYHQDIWHUWKHXQLWLVWXUQHGRII
*ORZXQWLOWKHXQLWKDVFRROHGGRZQWRDSSUR[LPDWHO\
°F.
Single
Left Rear Element
Single
Right Front Element
Dual
Left Front
Dual Element
Warming Zone
Single
Right Rear Element
CAUTION
SURFACE ELEMENT CYCLES
- When cooking on the surface elements it is possible
for the element to cycle on and off during cooking.
This will happen more frequently when a lower
power is selected however it can also occur on
higher settings as well.