LG LRG3093S, User Manual

O P E R AT I N G   I N S T R U C T I O N S

17

ENGLISH

USING THE CLOCK AND TIMER

HOW TO SET THE CLOCK

The clock should be set to the correct time of day for
the automatic oven timing functions to work properly.
The time of day cannot be changed during cooking or
self-clean mode.

Press the 

“CLOCK”

pad once to set.

Press the 

number

pads to enter the

time. Press the number pads the same
way you read them. For example, to set
12:12, press the number pads 

1, 2, 1,

and 

2

in that order.

If number pads are not pressed within
30 seconds after you press the

“CLOCK”

pad, the display reverts to

the original setting. If this happens,
press the 

“CLOCK”

pad and reenter

the time of day.

Press the 

“START”

pad.

To check the time of day when the display is showing
other information, simply press the 

“CLOCK”

pad.

HOW TO CHANGE HOUR MODE ON CLOCK
(12HR OR 24HR)

Your control is set to use a 12-hour clock. If you
would prefer to have a 24-hour time clock, follow the
steps below.

Press the 

“CLOCK”

pad for 3 seconds.

Press the number 

1

pad once for 12hr

and twice for 24hr.

Press the 

“START”

pad to accept the

desired change.

HOW TO SET THE TIMER

The timer does not control oven operations. The
maximum setting on the timer is 11 hours and 59
minutes.

Press the 

“TIMER ON/OFF” 

pad once

for minutes and seconds, press the pad
twice for hours and minutes.

Press the 

number

pad to select the

desired time. A maximum of 59 minutes
can be set using the minutes and
seconds function. To set times longer
than 59 minutes use the hours and
minute function (press the pad twice).

NOTE:

If you make a mistake, press the

“TIMER ON/OFF”

pad and begin again.

Press the 

“TIMER ON/OFF”

pad to start

the countdown.

NOTE:

If 

“TIMER ON/OFF”

is not pressed

the timer will return to the time of day.

When the timer reaches 

:00, “End”

will

show in the display. The clock will sound
with 3 beeps every 15 seconds until

“TIMER ON/OFF”

pad is pressed.

NOTE:

If the remaining time is not in the display, recall

the remaining time by pressing the 

“TIMER ON/OFF”

.

HOW TO CANCEL THE TIMER

Press the 

“TIMER ON/OFF”

pad.

POWER OUTAGE

If a flashing time is in the display, you have
experienced a power failure. You will need to reset
the clock time.

Press the 

“CLOCK”

pad once to reset. Enter the

correct time of day by pressing the appropriate
number pads. Press the 

“START”

pad.