45
What is DV?
Using DV, also known as i.LINK, you can connect a
DV-equipped camcorder to this recorder using a sin-
gle DV cable for input and output of audio, video,
data and control signals.
The i.LINK interface is also known as IEEE 1394-
1995. “i.LINK” and the “i.LINK” logo are trademarks.
•
This recorder is only compatible with DV-format
(DVC-SD) camcorders. Digital satellite tuners and
Digital VHS video recorders are not compatible.
•
You cannot connect more than one DV camcorder
at a time to this recorder.
•
You cannot control this recorder from external
equipment connected via the DV IN jack (includ-
ing two DVD Recorders).
•
It may not always be possible to control the con-
nected camcorder via the DV IN jack.
•
Digital camcorders can usually record audio as
stereo 16-bit/48kHz, or twin stereo tracks of 12-
bit/32kHz. The VCR/DVD Recorder can only
record one stereo audio track. Set DV Record
Audio to Audio 1 or Audio 2 as necessary (see
page 26).
•
Audio input to the DV IN jack should be 32 or
48kHz (not 44.1kHz).
•
Picture disturbance on the recording may occur if
the source component pauses playback or plays
an unrecorded section of tape, or if the power
fails in the source component, or the DV cable
becomes disconnected.
•
If DV Record Audio is set to Audio 2, but no Audio
2 signal is present, DV Record Audio will be reset
to Audio 1 automatically.
DV-Related Messages
You may see the following messages appear on your
TV screen when using the DV IN jack.
Not connected to Camcorder.
The camcorder is not connected properly, or the cam-
corder is switched off.
Too many devices connected.
The DV jack on this recorder supports connection to
just one camcorder.
Check the tape.
There is no cassette loaded into the connected
equipment.
Uncontrollable device.
The VCR/DVD Recorder cannot control the cam-
corder.
Updating the Information.
Camcorder is updating information for DV.
Camera mode.
Camcorder is set to camera mode.
Troubleshooting
If you cannot get a picture and/or audio through the
DV IN jack, check the following:
•
Make sure the DV cable is properly connected.
•
Try switching off the connected equipment, then
switch it back on.
•
Try switching the audio input.
Notes:
•
Depending on the connected camcorder, you may
not be able to control it using the Remote Control
supplied with this VCR/DVD Recorder.
•
Before you set the mode of your Camcorder to
camera mode, turn down the volume of connect-
ed Sound device. There can be a howling sound.
Summary of Contents for LRY-517
Page 26: ...26 ...