62
INTRODUCTION
HOOKUP
PLA
YBACK
RECORDING
EDITING
REFERENCE
Symptom
Picture or sound of
broadcasting channel is
weak or missing.
Can’t play disc record-
ed on this VCR/DVD
Recorder on another
DVD player.
Cannot record or did
not record successfully.
Stereo Audio Record
and/or Playback not
present.
Cause
Antenna or cables are loose.
Wrong Tuning Band is selected in the
VCR/DVD Recorder Setup menu.
The disc was recorded in Video mode.
Some players will not play even a
finalized disc recorded in Video mode.
The disc was recorded in VR mode.
Discs recorded with copy-once materi-
al cannot be played on other players.
The remaining blank space on the
disc is insufficient.
The source you are trying to record is
copy-protected.
When setting the recording channel,
the channel is tuned on the TV’s own
tuner.
When recording to a Video mode disc,
programs that are copy-once protect-
ed cannot be recorded.
TV is not Stereo-compatible.
Broadcast program is not in stereo for-
mat.
VCR/DVD Recorder A/V Out jacks are
not connected to TV A/V In jacks.
VCR/DVD Recorder Audio/Video Out
is not selected for viewing at the TV.
VCR/DVD Recorder’s TV audio chan-
nel is set to SAP or MONO.
Correction
Tighten connections or replace cable.
Try “Tuning Band Select” options; see
page 20 for details.
Finalize the disc; see page 27.
No solution.
The other player must be RW compati-
ble in order to play it.
No solution.
Use another disc.
You cannot record the source.
Select the channel on the VCR/DVD
Recorder’s built-in TV tuner.
Use a VR mode formatted disc for
copy-once material.
No solution.
No solution.
Make A/V connections. Stereo is avail-
able only via A/V output from VCR/DVD
Recorder.
Select AUX or A/V source as TV input.
Set TV audio channel mode to Stereo.
See “Changing TV Audio Channel” on
page 29.
Reset the VCR/DVD Recorder
If you observe any of the following symptoms...
When the VCR/DVD Recorder is plugged in,
but the power will not turn on or off.
When the display window does not working.
When the VCR/DVD Recorder does not oper-
ate normally.
You can reset the VCR/DVD Recorder as follows :
Press and hold the POWER button for more
than five seconds. This will force the
VCR/DVD Recorder to power off.
Press the POWER button again to turn the
VCR/DVD Recorder back on.
Unplug the power cord and then plug the
power cord again after more than five sec-
onds.
Summary of Contents for LRY-517
Page 26: ...26 ...