20
INSTALLATION
Test Run
Check if the range is properly installed and run a test
cycle.
1
Before using the cooktop for the first time, clean
it with a ceramic cooktop cleaner. This helps
protect the top and makes cleanup easier.
2
Turn the oven mode knob to the
Off
position to
start test.
3
Fill an induction-capable pot with water and
place it on a surface element. Turn on the
surface element. The LED bar should show the
setting and the water should heat. The LED
bar should not fluctuate. Repeat for all surface
elements.
4
After checking all the surface heating elements,
check the locking system by pressing
Probe
for three seconds. The oven door should lock
and the cooktop should not operate while the
Lockout function is turned on. Press
Probe
for
three seconds to disable Lockout.
5
Now check the oven's operation. Turn the oven
mode knob to select the
Bake
mode. 350 °F
appears in the display. Press
Start
.
6
The oven should finish preheating in 15 minutes,
and the convection fan should operate while the
oven is preheating.
7
After checking the oven's operation, turn the
temperature up to 450 °F and leave the oven on
for at least an hour to help remove any oil which
might cause smoke and odors when first using
the oven.
NOTE
Smoke may come out of the range when it is first
used.
Summary of Contents for LSIS3018SS
Page 66: ...66 Memo MEMO ...