7-10
K. REMOVING THE TURNTABLE MOTOR
(1) Remove the turntable.
(2) Remove the turntable shaft VERY CAREFULLY
with a slotted screwdriver. (Figure 16)
(3) Remove the base plate by removing 7 screws
securing it to the oven cavity. (Figure 17-a)
(4) Disconnect the leadwire from the turntable motor
terminals.
(5) Remove the 2 screws securing the turntable motor
to the oven cavity ASS'Y. (Figure 18-b)
NOTES:
• Remove the leadwire from the turntable motor
VERY CAREFULLY.
• Be sure to grasp the connector not the wires when
removing.
L. REMOVING CONVECTION HEATER
AND THERMISTOR (Figure 19)
(1) Remove the out case.
(2) Remove the air duct by removing six screws
securing it to the oven front plate, guide air and
glasswool-L cover.
(3) Disconnect the wire leads of air duct.
(4) Remove the magnetron.
(5) Remove the latch board assembly.
(6) Remove the bottom plate by removing four screws.
(7) Remove the four net screws securing chamber
assembly.
(8) Lift the chamber assembly from the oven cavity.
(9) Remove three screws securing the heater of the
chamber assembly.
(10) Lift the convection heater from the chamber
assembly.
Wire Leads
Turntable Motor
Figure 18-b
Figure 16
Figure 19
Figure 17-a
