3-11
COMPONENT ACCESS
1. Turn off the electrical supply and gas supply
going to the range and remove the oven racks.
2. Remove the four Fan cover screws and set the
fan cover aside.
3. To remove the fan blade :
- Remove the nut by
screwing clockwise. The
fan blade can be replaced
from inside oven.
4. To remove the fan motor assembly :
a) Pull the range out of its mounting location so
that you can access the rear of the unit.
b) Remove the rear panel from the unit (See step
5 on page 3-2 for procedure).
c) Disconnect the wire connection and remove
the 4 screws.
REMO
REMO
VING THE CONVECTION AN BLADE AND F
VING THE CONVECTION AN BLADE AND F
AN MO
AN MO
T
T
OR
OR
Fan cover
Nut
Fan cover
Screws
(3ea)
Mounting
Screws
(3ea)
Fan motor
Screws
(2ea)
Cavity
Inner Outer
Fan
blade
Support
Washer
Fan motor
Washer
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
CAUTION
• Be careful not to bend the fan blade
- Failure to do so can result in vibration, noise,
and poor performance of convection when
operating.
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
Summary of Contents for LSRG309ST
Page 77: ......