INSTALLATION INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE INSTALLATION
PREPARING FOR INSTALLATION
TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
•
Gas line shut-off valve
•
Pipe joint sealant that resists action of natural and
LP gases.
•
Flexible metal appliance connector (3/4” or 1/2” NPT
x 1/2” I.D.)
Never use an old connector when installing a new
range.
•
Flare union adapter for connection to gas supply line
(3/4” or 1/2” NPT x 1/2” I.D.)
•
Flare union adapter for connection to pressure
regulator on range (1/2” NPT x 1/2” I.D.)
•
Liquid leak detector or soapy water.
•
Lag bolt or 1/2” O.D. sleeve anchor (for concrete
floors only).
IN THE COMMONWEALTH OF MASSACHUSETTS
•
This product must be installed by a licensed
plumber or gas fitter.
•
When using ball type gas shut-off valves, they shall
be the T-handle type.
•
When using a flexible gas connector, it must not
exceed 3 feet in length.
Phillips screwdriver
Flat-blade screwdriver
Pencil and ruler
Pipe wrench(2)
(one for support)
Open-end or
adjustable wrench
Level
INSTALLATION SAFETY INSTRUCTIONS
(continued)
•
Items of interest to children should not be stored in
cabinets above a range or on the backsplash of a
range—children climbing on the range to reach
items could be seriously injured.
•
DO NOT attempt to operate the oven of this range
during a power failure.
CAUTION
WARNING
•
If a 30” clearance between cooking surface and
overhead combustible material or metal cabinets
cannot be maintained, protect the underside of the
cabinets above the cooktop with not less than 1/4”
insulating millboard covered with sheet metal not
less than 0.0122” thick. Clearance between the
cooking surface and protected cabinets
MUST
NEVER BE LESS THAN 24 INCHES.
•
The vertical distance from the plane of the cooking
surface to the bottom of adjacent overhead
cabinets extending closer than 1” to the plane of
the range sides must not be less than 18”. (See
the
Dimensions and Clearances
illustration in this
manual.)
ENGLISH
ENGLISHENGLISH
