3-5
COMPONENT ACCESS
REMOVING THE MAIN PCB AND KEY PCB ASSEMBL
REMOVING THE MAIN PCB AND KEY PCB ASSEMBL
Y
Y
1. Turn off the electrical supply going to the range.
2. Pull the controller from the range. (See page 3-4)
3. To remove the Main PCB, remove the bracket
and remove the 3 screws of Main PCB and
separate Main PCB after unplugging the
connectors.
4. Controller wire should be held by the wire holding
structure of controller assembly.
4. Controller wire should be held by the wire holding
structure of controller assembly.
5. To remove the Key PCB assembly Remove the 4
screws of the Main PCB supporter.
REASSEMBLY NOTE : When you reinstall the Key
PCB Assembly make sure that the upper brackets
of it are inserted into the correct guide then reinstall
the lower bracket screw.
Buzzer PCB
NFC PCB
Key PCB
Encoder PCB
WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
!
CAUTION
• Be careful when you work on the
electric range handling the sheet
metal part.
- Sharp edge may be present and you can cut
yourself.
- After complete separation of the Controller
from the product, please removed the PCB
Assembly.
!
Bracket
