3-12
COMPONENT ACCESS
1. Turn off the electrical supply and gas supply
going to the range and remove the oven racks.
2. Remove the 9 Fan cover screws and remove Fan
cover.
3. Remove 5 screws from the burner assembly and
then remove the burner cover U.
4. Remove 2 screws from the burner assembly and
then Remove the stabilizer.
6. To remove the fan motor assembly :
a) Pull the range out of its mounting location so
that you can access the rear of the unit.
b) Remove the rear panel from the unit (See step
3~4 on page 3-2 for procedure).
c) Disconnect the wire connection and remove
the 3 screws.
5. To remove the fan blade :
- Remove the nut by
screwing clockwise. The
fan blade can be replaced
from inside oven.
REMOVING THE CONVECTION F
REMOVING THE CONVECTION F
AN BLADE AND F
AN BLADE AND F
AN MOT
AN MOT
OR
OR
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
Nut
CAUTION
• Be careful not to bend the fan blade
- Doing so can result in vibration, noise, and
poor performance of convection when
operating.
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
Wire connection
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
3 screws
9 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
4 screws
3 screws
< burner cover U >
< Stabilizer >