20
INSTALLATION
9
Connect the tubing to the refrigerator.
NOTE
•
Before making the connection to the refrigerator, be
sure that the refrigerator power cord is not plugged
into the wall outlet.
•
Remove the plastic flexible cap from the water
valve.
•
Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown.
•
Insert the end of the copper tubing into the
connection as far as possible. While holding the
tubing, tighten the fitting.
Tubing
Clamp
¼ in. Compression Nut
Ferrule
(sleeve)
¼ in. Tubing
Refrigerator
Connection
10
Turn the water on at the shutoff valve.
Tighten any connections that leak.
CAUTION
•
Check to see if leaks occur at the water line
connections.
Leveling and Door Alignment
Leveling
The refrigerator has two front leveling legs. Adjust the
legs to alter the tilt from front-to-back or side-to side.
If the refrigerator seems unsteady, or the doors do
not close easily, adjust the refrigerator’s tilt using the
instructions below:
1
Turn the leveling leg to the left to raise that side
of the refrigerator or to the right to lower it. It may
take several turns of the leveling leg to adjust the
tilt of the refrigerator.
NOTE
•
A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
2
Open both doors and check to make sure that
they close easily. If the doors do not close easily,
tilt the refrigerator slightly more to the rear by
turning both leveling legs to the left. It may take
several more turns, and be sure to turn both
leveling legs the same amount.
