-8-12-
TROUBLESHOOTING
CN52
CN53
CN61
CN60
Door Lock System Failure,F10
or F20 ?
It is normal.
Check the wiring
Check the operation of door lock motor.
Press Lower Clear/Off button for 3
seconds. and try to open the door.
Does the door open?
Yes
Go to No 2
1
Unplug the unit
Is the Connector disconnected or loose?
Check the following:
(1) Between Main PCB and Relay PCB (CN51)
(2) Electric wiring CN52 and CN53 of relay PCB
(3) Electric wiring of Locking Motor and Micro Switch
(4) Electric wiring of CN60 and CN61 of Main PCB
Yes
Reconnect.
If defective harness,
replace or fix
2
yes
No
Note :
Just after self-clean start, the door lock motor starts
to rotate.
During this time if the door lock switch does NOT
operate properly after rotating twice, then supervising
circuit detects a Door Lock failure and the F10 or F20
error code appears.