Connecting
5
C
onnecting
2
h
c
/
v
Skip / Search / Seek / Tune
Returns to the previous step.
w
/
s
- List up / down
- Adjusts settings.
- Moves 10 MP3 / WMA fi les
backward or forward if there is no
folder or one folder on an USB.
- Moves to the previous or next
folder if there are more than 2 folders
on an USB.
ENTER / LIST
- Confi rms the settings.
- Checks fi les or preset stations.
i
DISP
- Press it, you can check the clock
time.
- Press and hold it, you can turn on/
off the display window and the light
of LED buttons.
j
RPT
Repeats playback.
k
INT
Intro scan.
l
Numeric buttons (1 to 6)
Selects a numbered preset station in
TUNER.
Battery Installation
Type 1
Type 2
2
1
Use only one CR2025 (3 V) lithium
battery.
Remove the battery if the remote
control is not used for a long
period of time.
Do not leave the product in a hot
or humid place.
Do not handle the battery with
metallic tools.
Do not store the battery with
metallic materials.
,
Note
Installation
Basic Installation
Before installing, make sure that the
ignition-switch is set to OFF and remove
the terminal of the car battery to avoid
short-circuiting.
Bend the claws
according to
the thickness of
the dashboard.
Control panel
1. Remove the existing receiver unit.
2. Make the necessary connections.
3. Install the installation sleeve.
4. Install the unit into the installation
sleeve.
Removing the existing
receiver unit
If there is already an installation sleeve for
the receiver unit in the dashboard, it must
be removed.
1. Remove the rear support from the unit.
2. Remove the control panel and trim
ring from the unit.
3. Insert the lever into the hole on one
side of the unit. Perform the same
operation on the other side and pull
the unit out from the mounting sleeve.
ISO-DIN Installation
Control panel
1. Slide the unit into the ISO-DIN frame.
2. Fit screws removed from the old unit.
3. Slide the unit and frame into the dash
opening.
4. Install the dash panel or adapter plate.
(According to models, this step may
not be needed.)
5. Install the trim ring to the unit.
6. Install the control panel to the unit.
