– 2 –
YOUR SAFETY FIRST
BEFORE YOU START
• Proper installation is the installer's responsibility!
– Read the entire manual before you begin. The Model number label is located on the front of oven,
behind doon See Figure 1. Mounting plate is located on back side of microwave oven.
See Figure 2.
BE SURE TO READ THE FOLLOWING SAFETY INSTRUCTIONS:
•
You will need TWO people to install this oven. It is heavy and could cause personal injury if not handled
properly.
•
Avoid Electrical Shock!
– Before you drill into the wall, note where electrical outlets are and where electrical wires might be behind
concealed in the wall,
YOU COULD RECEIVE AN ELECTRICAL SHOCK
if you contact electrical wires with
your
drill bit.
– Locate and disconnect the power of any electrical circuits that could be affected by installing this oven.
IF YOU DO NOT DISCONNECT THE POWER, YOU RECEIVE AN ELECTRICAL SHOCK.
•
ELECTRICAL RATING OF THIS OVEN : 120V AC. 60Hz.
– You need a 120V, 60Hz, AC only, 15A or 20A, fused electrical supply (located in the cabinet above the
microwave as close as possible to the microwave circuit) serving only the microwave.
Mounting Plate
Model Number Plate
Model Number Plate
Mounting Plate
Figure 1
Figure 2
For Your Safety
W A R N I N G
•
This oven should not be installed or located by anyone except properly qualified service personnel.
