Installation
WARNING: THIS APPLIANCE MUST BE EARTHED
The oven cannot be operated with the door open due to the safety interlocks built in the door mechanism
which switch off cooking functions when the door is opened. Operating the oven with the door open could
result in harmful exposure to microwave energy. It is important not to tamper with the door mechanism.
Do not place any object between the oven front face and the door or allow soil or cleaner residue
to accumulate on sealing surfaces.
Do not operate the oven if it is damaged. It is particularly important that the oven door closes
properly and that there is no damage to the (1) door (bent), (2) hinges and latches (broken or loosened), (3)
door seals and sealing surfaces.
The oven should not be adjusted or repaired by anyone except qualified service personnel.
PRECAUTIONS TO AVOID POSSIBLE
EXPOSURE TO EXCESSIVE
MICROWAVE ENERGY
WARNING
When heating liquids, e.g. soups, sauces and beverages in your microwave oven, delayed eruptive boiling can
occur without evidence of bubbling. This could result in a sudden boil over of the hot liquid. To prevent this
possibility the following steps should be taken:
1. Avoid using straight-sided containers with narrow necks.
2. Do not overheat.
3. Stir the liquid before placing the container in the oven and again halfway through the
heating time.
4. After heating, allow to stand in the oven for a short time. Stir or shake the contents (especially feeding
bottles and baby foods) and carefully check the temperature before use.
1. Remove all packing materials and accessories.
2. Place the oven on a level surface a minimum of 85cm above the floor with at least 30cm above and 10cm rear
space to allow adequate ventilation. The side of the oven should be kept clear so there is air flow for ventilation.
The front of the oven should be at least 8cm from the edge of the surface to prevent tipping.
An exhaust outlet is located on top or side of the oven. Blocking the outlet can damage the oven.
3. Plug your oven into a standard voltage household outlet. Ensure that the electrical circuit is at least 10 amps
and that the oven is the only appliance on the circuit.
NOTE: • This appliance should not be used for commercial catering purposes.
The wires in the mains lead are coloured in accordance with the following code:
Blue
- Neutral
Brown
- Live
Green and Yellow - Earth
If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly
qualified person in order to avoid hazard.
4
Summary of Contents for MS-2027C
Page 3: ... 3 Control Panel MS 2027C MS 2027CS ...
Page 15: ...P No MFL06500202 ...