LG MS408D Manual Download

Page: 46 / 60

Audio settings

This option allows you to listen to a movie at a lower vol-
ume without losing clarity of sound.
Set [DRC] to [On] for the Dolby Digital encoded files only
and [Comfort] for files with any encoding method.

Selects the type of digital audio signal when using the
HDMI OUT or DIGITAL AUDIO OUT (OPTICAL or COAXI-
AL) jack.

[HDMI PCM]:

Select if you connect this recorder’s

HDMI OUT jack to a device with two-channel digital
stereo decoder.

[HDMI Bitstream]:

Select if you connect this recorder’s

HDMI OUT jack to a device with LPCM, Dolby Digital
and DTS decoder.

[SPDIF PCM]:

Select if you connect this recorder’s

DIGITAL AUDIO OUT jack to a device with two-channel
digital stereo decoder.

[SPDIF Bitstream]:

Select if you connect this

recorder’s DIGITAL AUDIO OUT jack to a device with
LPCM, Dolby Digital and DTS decoder.

[48KHz]:

Select this if your A/V Receiver or Amplifier

is NOT capable of handling 192 KHz and 96 KHz
signal. When this choice is made, this unit
automatically converts any 192 KHz and 96 KHz sig-
nals to 48 KHz so your system can decode them.

[96KHz]:

Select this if your A/V Receiver or Amplifier

is NOT capable of handling 192 KHz signals. When
this choice is made, this unit automatically converts
any 192 KHz signals to 96 KHz so your system can
decode them.

[192KHz]:

Select this if your A/V Receiver or Amplifier

is capable of handling 192 KHz signals.

If audio signal is outputted through HDMI OUT jack
and the resolution is set to lower than 720p, the
sampling frequency can be limited to 48 KHz.

Check the documentation for your A/V Receiver or
Amplifier to verify its capabilities.

Display settings

Selects the aspect ratio of the connected TV.

[Letter Box 4:3]:

Select this when connecting to a stan-

dard 4:3 screen TV and prefer the wide picture with
bands on the upper and lower portions of the screen.

[Pan Scan 4:3]:

Select this when connecting to a stan-

dard 4:3 screen TV and prefer the wide picture on the
entire screen and cuts off the portions that do not fit.

[16:9 Original]:

Select when a 16:9 wide TV is

connected. The 4:3 picture is displayed with an original
4:3 aspect ratio, with black bars appearing at the left
and right sides.

[16:9 Wide]:

Select when a 16:9 wide TV is connected.

The 4:3 picture is adjusted horizontally (in a linear
proportion) to fill the entire screen.

(Digital Noise Reduction)

Set this option to [Auto] to reduce the digital noise, which
may appear especially on fast-moving pictures, produced
in the MPEG compression process.

Sets the output resolution of the Component and HDMI
video signal. Refer to “Resolution Setting” for details
about the resolution.

[Auto] –

If the HDMI OUT jack is connected for TVs

providing display information (EDID), automatically
selects the resolution best suited to the connected TV.
If the COMPONENT VIDEO OUT is only connected,
this changes the resolution to 1080i as default resolu-
tion.

[1080p]:

Outputs 1080 lines of progressive video.

[1080i]:

Outputs 1080 lines of interlaced video.

[720p]:

Outputs 720 lines of progressive video.

[576p]:

Outputs 576 lines progressive video.

[576i]:

Outputs 576 lines of interlaced video