LG OTW630B, Installation Manual

ENGLISH

6

2.  How to attach to masonry walls

Please follow the below direction.

•

Check the material of the wall and the thickness of the finishing.

•

Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick 

and hallow block that do not crack.

•

Do not mount the device on the walls made from plasterboard or medium density fiberboard (MDF). In this case, the 

anchor and screws must be inserted into the concrete behind the finish surface. If there is no concrete on the other 

side, then you must first install a separate hanger to securely install the anchors and screws.

•

When installing the product on wall material not designated, install the product so that each location can withstand 

the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.

•

Use the Ø 8 mm drill bit for concrete and hammer (Impact) drill. 

  1  

  2  

  3  

Wall mounting anchor

  4  

  5  

Wall mounting screw

  1  

Use a drill bit Ø 8 mm to drill a hole for the anchor location within a depth of 80 mm to 100 mm.

  2  

Clean the drilled hole.

  3  

Insert the sealed wall mounting anchor to the hole. (When inserting the anchor, use a hammer.)

  4  

Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part to face 

upward.

  5  

Align the wall mounting screw to the hole and tighten it. Then, fasten the screws at torque of 45 kgf/cm to  

60 kgf/cm.