4
SAFETY INSTRUCTIONS
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Indoor Installation
WARNING
y
Do not use the projector outside and
do not expose the product to any
humidity or water.
- Since the product is not waterproof,
this may result in a fire or electric
shock.
y
Do not place the projector in direct
sunlight or near heat sources such as
radiators, fires, stoves, etc.
- This may result in fire.
y
Do not place flammable materials
such as aerosols near the projector.
- This may result in fire.
y
Do not allow children to cling to or
climb up to the projector.
- This may cause the projector to fall,
causing injury or death.
y
Do not install the product in a place with
no ventilation (e.g., on a bookshelf or in
a closet) or on a carpet or cushion.
- This may result in fire due to the
increase in internal temperature.
y
Do not place the product close to
sources of steam, oil, or oil mist, such
as humidifiers and kitchen counters.
- Failure to do so may result in fire,
electric shock, or corrosion.
y
Do not install the product onto a wall
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
y
Do not place the projector where it
might be exposed to dust.
- This may result in fire.
y
Do not use the projector in a damp
place such as a bathroom where it is
likely to get wet.
- This may result in fire or electric
shock.
y
Do not allow a tablecloth or curtain to
block the air vent.
- This may result in fire due to the
increase in the internal temperature.
y
Ensure good ventilation around the
projector. The distance between the
projector and the wall should be at
least 30 cm.
- This will prevent fire due to the
increase in the internal temperature.
CAUTION
y
When placing the projector on a table
or shelf, be careful not to put it near
the edge.
- The projector could fall due to bal-
The projector could fall due to bal-
The projector could fall due to bal-
ance problems, which may cause
personal injury or damage to the
product. Make sure to use a pro-
jector cabinet or stand that fits the
projector.
y
When moving the projector, make
sure to switch it off and remove the
power plug and cords.
- The power cord may be damaged,
resulting in fire or electric shock.
y
Do not place the projector on an
unstable or vibrating surface such as
a wobbly shelf or a slope.
- It may fall and cause injury.
