4
SAFETY INSTRUCTIONS
y
Do not install the product onto a wall
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
y
Do not place the projector where it
might be exposed to excessive dust.
- This may cause a fire.
y
Do not use the projector in a damp
place such as a bathroom where it is
likely to get wet.
- This may cause a fire or an electric
shock.
y
Do not allow a tablecloth or curtain to
block the vents.
- This may cause the internal
temperature of the projector to rise
and cause a fire.
y
The distance between the projector
and the wall should be more than 30
cm for ventilation purposes.
- Otherwise, this may cause the
internal temperature of the projector
to rise and cause a fire.
CAUTION
y
When installing the projector on a
table, be careful not to place it near
the edge.
- The projector may fall causing injury
to persons or damage to the projec-
tor. Make sure that you use a stand
suitable for the size of projector.
y
Turn off the projector, disconnect the
power supply and remove all connec
tions before moving the projector.
- A damaged cord may cause a fire
or an electric shock.
y
Do not install the projector on an
unstable or vibrating surface such as
a vibrating shelf or tilted surface.
- It may fall and cause injury.
y
Be careful not to tip the projector over
when connecting external devices to
the projector.
- This may cause injury to persons or
damage to the projector.
Power
WARNING
y
The ground wire should be connected.
- Inappropriate earth grounding may
cause damage to the projector or
an electric shock when there is an
electrical surge.
If the projector must be installed at
a place where earth grounding is not
possible, purchase a circuit breaker
and connect the projector to its wall
outlet.
Do not ground the projector to the
gas pipe, water pipe, lightning rod or
telephone line, etc.
y
The power plug should be fully
inserted into the wall outlet.
- Unstable connection may cause a fire.
y
Do not place heavy objects on the
power cord or place the cord
underneath the projector.
- This may cause a fire or an electric
shock.
y
Never touch the power plug with a
wet hand.
- This may cause an electric shock.
y
Do not connect too many devices to
the same power extension.
- Overheating may cause a fire.
y
Remove dust or contaminants around
power plug pins or wall outlets.
- This may cause a fire.
y
To turn off the main power, remove the
power plug, which should be positioned
so it is easy to access for operation.
