Installation Method
Owner’s & Installation Manual 7
ENGLISH
CN-REMO
LO2K
J15
LO1K
LO1D
C07D
C01K
J14
CN-DISP
CN-M
CN-ZONE
C
IC01A
5
㎝
The position of the fixing screws
Main
indoor unit
Red Yellow Brown
Mainfraim
Fixing the
remote controller
1
Put the installation paper on the place and determine the
position and height of the fixing screws of the wired remote
controller.
• Refer to the printed side of the installation paper.
2
Plug the connecting cable into the indoor unit.
• The product is being shipped with the cable
connected only to the remote controller.
Fix the connecting cable with the cable rack.
3
Remove the installation paper before installing
the remote controller so that it can fit into the
right place.
* Do not embed the remote controller into the wall. (It may cause the breakdown of the temperature
sensor.)
* If you want to install a number of remote controller on the same place in a vertical line, install them at
regular intervals of 5cm. (It may cause the breakdown of the temperature sensor.)
❐
Supply the power after connecting wired remote controller.
When you need to change wired remote controller, switch off the main power and change it
Before switch off the main power if changed the wired remote controller,you can't use the option
function of the indoor unit.
Installation Method
