Ownerʼs & Installation Manual
11
ENGLISH
Necessary functions before using
Out door
Room Temp
Total on
Central Run
Defrost
Preheat
PQRCFCS0C
FAN
SPEED
ROOM
TEMP
FAN
SPEED
MODE
Group No.
Indoor Unit No.
TEMP
TEMP
TEMP
TEMP
1
If you want to set the address on the display panle,
press both temperature control buttons (
s
/
t
) same
time for three seconds.
2
Press the temperature-increasing button to change the
group number. Press the temperature-decreasing
button to change the indoor unit number.
e.g. As shown on the left side panel, it displays 23.
Group No. : 2
Indoor Unit No. : 3
3
Set the address by pressing both temperature control
buttons again (
s
/
t
) at the same time for three
seconds.
• If you connect the indoor unit to the central controller, you should set the network
address of the indoor unit so that the central controller could recognize it.
• The center-control address is composed of the group number and the indoor-unit
number.
Setting the Central-Control Address
Please set the address while using the central controller.
You don't need to set address if you don't use central controller.
h
Note : The remote controller displays 'HL' if central controller has locked the remote controller .
